Welcome!

Welcome to my world of pipes. On these pages you will see some of what goes on in my workshop. A bit of work-in-progress, mess-ups (they do happen!) and also some other pipe-related posts.
I love talking about and discussing pipes, so feel free to contact me at charl.chillfactor@gmail.com.
Should you wish to have a look at my pipes, please drop in at my website (http://goussardpipes.com/).




February 14, 2012

Freehand drilling - Part 2

Some of you guys might remember that I had a disastrous previous episode with freehand drilling. This is my second attempt at it, although somewhat of a wuzz-try I admit!
Here is how I did it this time around:



First I drew out all the lines for air hole, mortise and tobacco chamber. Then small off cut pieces of briar was glued into place as in the above photo. These were used as support for a live center in the tail stock of the lathe, with the bit chucked into the headstock.



With freehand drilling, the drilling procedure works a bit different for me than with normal drilling. First I drill the mortise, as normal.




But then I immediately went to drilling the chamber, instead of the air hole. The above photo shows where I am using a normal spade bit to pilot the hole.




Here you can see how the tail stock is used as support to feed the stummel onto the bit. After the initial cut with normal spade bit, a chamber bit is used to finish the hole.




The final step was to drill the air hole. This time the drilling was done real "freehand".


PS - Dead center this time around.


PSS - No whisky needed to drown my sorrows, although a celebratory one was consumed!









1 comment:

  1. Awesome post Charl, thank you for taking the time to show us step by step the work involved. Fascinating stuff, well done!

    ReplyDelete