Welcome!

Welcome to my world of pipes. On these pages you will see some of what goes on in my workshop. A bit of work-in-progress, mess-ups (they do happen!) and also some other pipe-related posts.
I love talking about and discussing pipes, so feel free to contact me at charl.chillfactor@gmail.com.
Should you wish to have a look at my pipes, please drop in at my website (http://goussardpipes.com/).




April 9, 2012

Stemwork Part 3 - Finishing

This is where I finished last time. The rod was rough-sanded and filed, and checked with a small square to keep it straight from tenon to tip. The button also have not been worked on yet.
Just by the way, most pre-formed tapered stems will not have a straight line from tenon to bit.
Now I will start working the button. First it is rough shaped on the 25mm beltsander and then fine tuned with files and nailfiles, until I'm satisfied with the shape.

Then the rest of the stem follows. Depending on the condition of the stem at this stage, I start with sanding in either 220 or 320 grit. If I did the job well, most cases will start with 320 and then work up towards 400 grit. Sanding above 400 grit is a waste of time, because the tripoli I use (and most other guys, I think) have a grit of 400.

For the 5mm or so just in front of the button, I use nail boards. Just with sandpaper you just can't get that bit sufficiently smoothed.

And here is the stem just before polishing. Every millimeter has been sanded and smoothed. Ebonite is a bit of a bugger and polishing might just reveal a little scratch or indentation that was missed, and it might just be that you have to go back and repeat a step or two.

Final wax with carnauba and a clean wheel and that is it!











No comments:

Post a Comment